When your garage door remote or keypad stops working but the wall button still opens the door, the problem is usually the remote, the keypad or a setting on the opener, not the door. Start with the simple fixes below.
If the remote doesn't work
- Replace the battery. It's the most common cause. Many remotes use a small coin battery.
- Check the lock feature. Many wall controls have a lock or vacation button that blocks remotes. Look for a lock symbol or a blinking light.
- Get closer. If the remote works only right next to the door, the battery is weak or the opener's antenna is blocked or damaged.
- Reprogram the remote. Press the learn button on the opener and follow your opener's instructions to pair the remote again.
- Look for interference. New LED bulbs in the opener or nearby devices can sometimes interfere with the signal.
If the keypad doesn't work
- Replace the battery. Most outdoor keypads run on a 9-volt or AA batteries.
- Check the lock. The same wall control lock that blocks remotes can block keypads too.
- Clear and re-enter the code. Follow your keypad's instructions to reset the PIN.
- Check for sun or heat damage. In Gilbert, keypads on west-facing walls take a beating. Faded or sticky buttons may mean it's time for a new keypad.
If nothing works, including the wall button
- Make sure the opener is plugged in and the outlet has power
- Check the circuit breaker and any GFCI outlet in the garage
- Look for a burned-out light on the opener
- Listen for the motor; humming without movement may mean a broken spring or stripped gear
When to call a technician
Call if the opener hums but doesn't lift, runs and stops, reverses for no clear reason after you've cleaned and aligned the sensors, or doesn't respond at all with power present. Opener repairs in the Phoenix area typically cost about $75 to $300, according to HomeGuide, and a new opener installed runs about $250 to $500.
Get help
Local technicians serve Gilbert, Queen Creek and San Tan Valley. Send a request below or call (480) 788-5344.